Side Handle - DeWalt DW563 Manual De Instrucciones

329528-01,00,DW563 8/15/00
and drilling operations cause chips to fly. Flying particles can cause
permanent eye damage.
• Always use the side handle supplied with the tool. Keep a
firm grip on the tool at all times. Do not attempt to operate this tool
without holding it with both hands.
• Hammer bits and tools get hot during operation. Wear gloves
when touching them.
• CAUTION:DO NOT TOUCH ANY METAL PARTS OF THE
TOOL when drilling or driving into walls, floors or wherever live
electrical wires may be encountered! Hold the tool only by
insulated grasping surfaces to prevent electric shock if you drill or
drive into a live wire.
CAUTION: Some wood contains preservatives such as copper
chromium arsenate (CCA) which can be toxic. When cutting these
materials extra care should be taken to avoid inhalation and minimize
skin contact.
Use of this tool can generate dust containing
WARNING:
chemicals known to cause cancer, birth defects or other
reproductive harm. Use appropriate respiratory protection.
• The label on your tool may include the following symbols.
V ........................volts
A ........................amperes
Hz ........................hertz
W ........................watts
min ........................minutes
........................alternating current
........................direct current
n o
........................no load speed
........................Class II Construction
.../min ......................revolutions or reciprocation per minute
BPM ........................beats per minute
All manuals and user guides at all-guides.com
12:21 PM Page 3
FIGURE 1

Side Handle

CAUTION: Always use side handle when provided and hold
hammer with both hands. A side handle is supplied with this hammer.
It clamps to the front of the gear case as shown in Figure 1 and can
be rotated 360˚ to permit right or left hand use.
Switch
To start hammer, depress the trigger switch (Figure 2). To stop
hammer, release the switch. To lock the trigger switch in the ON
position for continuous operation, depress the trigger switch and
push up the locking button. The tool will continue to run. To turn
the tool OFF, from a locked ON condition, squeeze and release the
trigger once. Before using the tool (each time), be sure that the
locking button release mechanism is working freely.
Be sure to release the locking mechanism before disconnecting the
plug from the power supply. Failure to do so will cause the rotary
hammer to start immediately the next time it is plugged in. Damage
or injury could result.
The variable speed trigger switch permits speed control. The
farther the trigger switch is depressed, the higher the speed of the
rotary hammer.
The reversing lever is used to reverse the rotary hammer for
3