Rampage 88625 Instrucciones De Instalación

0
7-18 Jeep Wrangler JK & JK Unlimite
Jeep Wrangler JL & JK Unlimited
Jeep Galdiator
For proper installation and best possible fit, please read all instructions BEFORE you begin.
For technical assistance or to obtain missing parts, please call Customer Relations at 1-800-328-2409.
Important Safety Information
• CAUTION - Before driving, ensure that the bumper is properly secured to vehicle.
• Periodically check all components for tightness.
Contents
Front Bumper
(Fog Lights Sold Separately)
12mm Nylock
Nuts (8)
Tools Required
Socket Wrench Socket Set
Installation
1
Remove the factory bumper, then remove the factory fog lights and wiring from the bumper.
2
Install the factory fog lights into the backside
of the new Front Tube Bumper. Line up the two
top tabs of the light housing with the two tabs
on the bumper. Insert a provided 5mm bolt with
one flat washer through the fog light tab and
through thetab on the bumper. Add another flat
washer then add the Nylock nut. Leave loose
until all the fog light hardware is installed, then
tighten all hardware. See Figure 1
NOTE: Some JL Wranglers use a 3-bolt bracket
for the fog light. These fog lights can still be
installed but will need to have the 2-bolt side
trimmed off and a hole drilled in the housing to
install the light.
Rampage part numbers 5083059 (Driving) and
5083060 (Fog) can also be used.
Installation Instructions
Tube Front Bumper
NOTE: Actual product may vary from illustration.
L-Shaped
Bracket (2)
5mm Bolts (4)
Wrench Set Phillips
Screwdriver
Figure 1
Page 1 of 2
12mm x 35mm
Bolts (8)
5mm Washers
(8)
Safety glasses
4-bolt JL Wrangler Fog
Light (JK is similar)
IS-88625_RevB
12mm Washers
(16)
5mm Nylock
Nuts (4)
Helper
3-bolt JL Wrangler Fog
Light (requires modifi-
cation)