Sartorius YDP12IS-0CEUV Instrucciones De Instalación página 4

Switching between Modes
§ Turn off the printer, press the "FEED"
button; turn the printer back on while
holding down the "FEED" button
§ Let go of the "FEED" button when the
control LED in the "FEED" button
flashes in red
> The control LED goes out
§ Wait until the control LED in the
"FEED" button flashes in green; then
immediately press the "FEED" button
and hold it down
§ Wait until the control LED in the
"FEED" button lights up in amber
(orange); then immediately let go
of the "FEED" button
§ Wait until the control LED in the
"FEED" button lights up in green
> The printer is now switched to another
mode
Note
Let go of the button immediately
when the control LED in the "FEED"
button lights up in amber (orange).
If it is held down too long, the printer
may switch to the "Download"
operating status. The printer can only
be changed from this status by
downloading firmware. In this case,
please contact our service department.
4
All manuals and user guides at all-guides.com
immediately immediately immediately immediately
Activating Paper Recognition
For use as a label printer, activate
paper recognition, so that the printer
recognizes the end of the label.
Do not activate Do not activate
! Do not activate paper recognition Do not activate Do not activate
when using continuous paper, as this
may lead to a paper end error. If,
however, the printer signals the end of
the paper after printing only a few
lines (the red error LED in the "FEED"
button will light up, activate paper
recognition using the label
supplied with the printer.
If the printer was used with
continuous paper (for example, with
the setting "Line Printer" on the isi
terminal) and you now wish to use it
as a label printer, you need to activate
paper recognition first. To do so,
switch the printer to "Line Mode" with
the label paper inserted in order to
acti-vate paper recognition in this
mode. Then switch the printer back
to "Page Mode."
To do this:
§ Switch the printer to "Line Mode":
Turn off the printer, press the "FEED"
button; turn the printer back on while
holding down the "FEED" button.
§ Let go of the "FEED" button when the
control LED in the "FEED" button
flashes in red
§ Wait until the control LED in the
"FEED" button goes out and then
flashes in green, then immediately
press the "FEED" button and hold it
down.
label label paper label paper paper paper
label paper