Kohler VESSELS K-2804-P5 Instrucciones De Instalación página 4

CAUTION: Risk of personal injury or product
damage. Large lavatories are very heavy. Get help
lifting the lavatory into place.
Temporarily position the lavatory in the countertop cutout
so the "Kohler" logo is visible. The logo is on the
underside, near the drain.
Follow either of the following two methods before applying
sealant:
S
Trace a pencil line on the countertop around the
entire outside edge of the lavatory; or
S
Apply masking tape to the countertop around the
entire outside edge of the lavatory to aid sealant
clean-up. The masking tape should be applied
approximately 1/8" (3mm) from the lavatory edge.
Be sure the tape is applied smoothly around the
entire lavatory.
Remove the lavatory.
Drill the faucet holes.
Install the faucet to the countertop according to the
manufacturer's instructions.
Install the drain to the lavatory according to the drain
installation instructions.
Apply two beads of sealant to the inside of the pencil line.
Spread the sealant evenly with a putty knife.
CAUTION: Risk of personal injury or product
damage. Large lavatories are very heavy. Get help
lifting the lavatory into place.
Note the location of the "Kohler" logo. The lavatory should
be installed so the logo is visible after installation.
Carefully position the lavatory in the cutout, and press
down firmly.
A
1007278-2-
"Kohler" Logo
4
C L Of Fittings
Fig. #9
Fig. #10
Fig. #11
Kohler Co., Kohler, WI, U.S.A.