Guarantee; Parts Subject To Wear And Tear - Solo 546 Manual De Instrucciones

10. Guarantee

The manufacturer guarantees problem free quality
and will cover the cost of replacing parts which are
found to be faulty in material or show
manufacturing defects within the prescribed
guarantee period after the date of purchase. Please
note that specific guarantee conditions may differ
from country to country. When in doubt, please ask
the vendor of the goods. The vendor of the product
is responsible for guarantee applications.
We hope you will understand that we cannot be
liable for damage resulting from these causes:
Non-compliance with operating instructions.
Neglecting required maintenance and repair
jobs.
Damage caused by improper carburettor
adjustment.
Wear from normal use.
Obvious overload by continuously exceeding
the upper performance limit of the product.
Using non-approved tools.
Use of force, improper treatment, misuse and
accidents.
Damage from excessive heat due to dirt build
up around the cooling fan housing.
Attempted adjustments and repairs by non-
qualified persons.
Use of unsuitable spare parts or non-original
parts if such parts are the cause of the damage.
Use of unsuitable or stale fuel.
Damage caused by using the product in the
hire or rental industry.
Normal cleaning, adjustments or maintenance jobs
cannot be claimed as part of the guarantee.
All guarantee work must be carried out by a service
centre authorized by the manufacturer.
Maintenance and repair
Maintenance and repair of modern motorized
devices, as well as their safety-relevant assemblies,
require qualified, specialized training and a
workshop equipped with special tools and test
devices.
Thus SOLO recommends that you have a specialized
SOLO workshop carry out all work that is not
described in these operating instructions. Your
SOLO specialist has the required training,
experience, and equipment at his disposal to
provide you with the most cost-effective solution
and can help you in many ways with advice and
service.
Guarantee ; Parts subject to wear and tear
Replacement parts
Dependable operation and the safety of your device
also depend on the quality of the replacement parts
that you use. Use only original SOLO replacement
parts.
Only original parts come from the production of the
device and thus guarantee the highest possible
material quality, dimensional accuracy, function,
and safety. Original replacement parts and accessory
parts are available from your dealer. He also
maintains the requisite replacement part lists to
determine the required replacement part numbers,
and he is constantly provided with information
concerning detail improvements and innovations in
the replacement part offering.
Please note as well that guarantee performances
from SOLO are not possible if parts other than SOLO
original parts are used.

11. Parts subject to wear and tear

Various parts are subject to application-specific wear
or to normal wear and must be replaced in good
time if necessary. The following parts are subject to
normal wear and are not covered by the
manufacturers guarantee:
Blade and blade fixing
Friction pads
Air filter
Spark plug
Fluids, such as engine and gearbox oil
Drive belts on lawnmowers with self-drive
In conformance with the product liability law we
want to clearly point out that we are not liable for
any damages which may occur due to improper
handling, or repair. Furthermore, we are not
responsible for any damage that may occur if
replacement parts other than SOLO replacement
parts, or parts that were not authorized by SOLO,
have been used. In addition we are not liable for
any damage that may occur if repair work was
performed by any source other than the Customer
Service or an authorized Service Center. This liability
exclusion applies also to accessories and
supplemental parts.
In the best interest of continued technological
progress we reserve the right to change the design
and configuration of any product without prior
notice.
For that reason, no claims can be accepted with
reference to text and illustrations in this manual.
ENGLISH 19