Dash Disassembly; Kit Preparation - Metra 99-6515 Instrucciones De Instalación

DASH DISASSEMBLY

1. Remove the covers from the (4) "radio
removal tool holes" in the factory radio.
(Figure A)
2. Using Metra's 86-5618 radio removal
tools, pull the factory radio from the
dash. (Figure B)
3. Remove (1) 10mm bolt from the center
rear of the metal radio support and (2)
Phillips screws from both sides of the
support then remove it from the sub
dash. (Figure C)
Continue to Kit Preparation
2
(Figure A)
(Figure B)
(Figure C)

KIT PREPARATION

1. Trim the area at the bottom of the sub
dash opening to allow for clearance of
the radio housing. (Figure A)
2. Secure the radio housing to the sub dash
with the factory hardware. (Figure B)
Continue to Kit Assembly
Areas to be trimmed
(Figure A)
(Figure B)
|
1.800.221.0932 MetraOnline.com