Kit Assembly - Metra 99-6515 Instrucciones De Instalación

DIN radio provision with pocket
1. Remove the metal DIN sleeve from the
aftermarket radio.
2. Slide the sleeve into the radio housing
and secure by bending the metal locking
tabs down. (Figure A)
3. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or AXXESS. Test the radio for proper
operation.
4. Slide the radio back into the sleeve until
it clicks in. (Figure B)

KIT ASSEMBLY

(Figure A)
(Figure B)
ISO DIN radio provision with pocket
1. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
2. Secure the ISO brackets to the radio
with the screws supplied with the radio.
(Figure A)
3. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or AXXESS. Test the radio for proper
operation.
4. Slide the radio into the radio opening
until the side clips engage. (Figure B)
5. Snap the ISO trim panel into the radio
housing. (Figure C)
(Figure A)
(Figure B)
(Figure C)
REV. 9/20/2017 INST99-6515
3