Ryobi P610 Manual Del Operador página 13

Ocultar thumbs Ver también para P610:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

PLANING EDGES
See Figure 11.
Follow the directions in Operating the Planer. Hold the edge
guide firmly against the edge of the work surface.
ATTACHING THE EDGE GUIDE FOR MAKING
RABBET CUTS
 Lock the switch by placing the lock-off button in the center
position.
 Remove the battery pack from the tool.
 Attach the bracket to the left side of the planer using the
knob bolt.
 Attach the edge guide loosely to the bracket using the
knob nut and the carriage head bolt.
 Adjust the edge guide to the desired width for the rabbet
cut.
 Tighten the retaining knob securely.
MAKING RABBET CUTS
See Figure 12.
Follow the directions in the Operating the Planer section
earlier in this manual. Hold the edge guide firmly against the
edge of the work surface.
The depth of the rabbet is determined by the depth of the
cut and the number of passes made along the work surface.
The maximum depth of the rabbet cut is 1/2 in. Cuts should
be made in passes of 1/64 in. or less to reach the desired
depth. The width of the rabbet cut may be adjusted by
moving the edge guide.
OPERATION
WORKPIECE
13
EDGE GUIDE
EDGE GUIDE
WORKPIECE
Fig. 11
Fig. 12

Publicidad

Tabla de contenido
loading

Tabla de contenido