Replacing The Belt - Ryobi P610 Manual Del Operador

REPLACING THE BELT

See Figures 16 - 17.
When replacing the belt, use recommended replacement
belt only (Part No. 570279002).
 Remove the battery pack from the tool.
 Remove the belt cover screws.
 Remove the belt cover.
 Force the old belt from the small pulley by turning in the
direction shown. As you turn the belt, pull and work it
off the small pulley until it has been completely removed
from both pulleys.
 Install the new belt over the large pulley. As you turn the
belt, push and work it onto the small pulley until it is in
place.
 Make sure the belt is flush with the edge of both
pulleys.
 Replace the belt cover.
 Install the belt cover screws and tighten securely.
NOTE: Do not overtighten the screws.
MAINTENANCE
16
BELT COVER
SMALL PULLEY
LARGE PULLEY
SCREWS
Fig. 16
Fig. 17