Remote Unit Advanced Buttons; Troubleshooting - Rotel T14 Manual De Instrucciones

14
• <PRUNE STATION>: Select between "Yes" or "No". The Prune setting
allows you to remove stations that are not active or can not be received.
NOTE: Prune will remove unavailable stations from both the Station
List and the DAB Preset List.
• <DAB PRESET>: Displays all 30 of the DAB/DAB+ preset stations and
allows tuning to the selected preset by pressing the PUSH SELECT knob
8
on the front panel or the ENT button on the remote control.

Remote Unit Advanced Buttons

MENU Setting J
To enter the setup menu, press the MENU
and you will see the following display to configure additional settings:
SETUP
> POWER OPTION
DISPLAY DIMMER
• POWER OPTION: In Normal mode, the network connection is turned OFF
when the unit is in standby mode. Setting this to Quick leaves the network
connection active during standby mode. Use Quick mode to reduce the
power on time allowing the network to stay connected. "Normal" is the
factory default.
Valid settings include: Quick, Normal.
NOTE: When the POWER OPTION is configured to Quick, the T14
will consume additional power in standby mode.
• DISPLAY DIMMER: Changes the display brightness.
• POWER LED DIMMER: Changes the Power LED brightness.
NOTE: These settings are stored permanently even after the T14 is
powered off.
• VERSION: Shows the current software version.
• EXIT: Exits this setting menu.
DIM Button C
Remote Only
Press the DIM button repeatedly to change the DISPLAY brightness.
NOTE: Adjustment made using the DIM
and not saved after powering off the T14.

Troubleshooting

Most difficulties in audio systems are the result of incorrect connections, or
improper control settings. If you encounter problems, isolate the area of the
difficulty, check the control settings, determine the cause of the fault and
make the necessary changes. If you are unable to get sound, refer to the
suggestions for the following conditions:
J
button on the remote control
C button is temporary only
Power Indicator Is Not Illuminated
The power Indicator should be illuminated, either Blue (on) or Red (standby),
whenever the unit is plugged into the wall power outlet and the power button
is depressed. If it does not illuminate, test the power outlet with another
electrical device, such as a lamp. Be sure the power outlet being used is
not controlled by a switch that has been turned off.
Network Does Not Work
If you have trouble connecting to your wireless network, check your network
setting carefully, these steps may help to resolve the problem.
1. Confirm that a Wi-Fi network works, ie, PC can access the Internet using
the same network.
2. Check that your network's firewall is not blocking any outgoing ports.
3. Make sure the placement of your unit allows it to receive the Wi-Fi signal.
4. The T14 supports an optional USB-ETHERNET adapter allowing installation
on a wired network. For more information contact your authorized Rotel
dealer.
No Sound
1. Check the cables between the output and the pre-amplifier inputs, be
sure they are connected properly. Refer to Figure 3.
2. Music played from Play-Fi App are affected by the speed of your internet
connection. If you find that music is cutting out regularly, check the signal
strength of the Wi-Fi network, consider the installation of Wi-Fi repeaters
or contact your Internet service provider or authorized Rotel dealer.
3. Make sure the station you selected is operating at the current hour. The
station can be broadcasting from a different time zone.
Cannot Tune to DAB/DAB+ Preset Station
Some stations may become unavailable and will be displayed in the Station
List with a "?" character in front of the station name. These stations are no
longer broadcasting or received by the T14. Presets that are set to these
stations will not function and if selected the T14 will display the DAB menu.
To remove stations no longer transmitting, use the PRUNE function in the
DAB Menu. This will remove these stations from the Station List and from
the Preset list.
T14 Network/FM/DAB+ Tuner