Horizon Global 24970 Instrucciones De Instalación página 5

3. Remove lower fascia – a.) using a Philips screw driver, remove (2) screws located at each end of lower fascia, near wheel well, (1) per side. b.) Using
a plastic trim panel tool or flat head screw driver, remove (3) plastic push-pin rivets from bottom edge of fascia. c.) From underside of lower fascia, pull
down on fascia clips to release the lower fascia from upper fascia while gently pulling rearward.
b.)
a.)
c.)
©2017 Horizon Global™ Corp - Printed in Mexico Sheet 5 of 21 24970NP 12-4-17 Rev. A