Horizon Global 76333 Instrucciones De Instalación página 5

2b. Remove fascia - Using a flat head screw driver, remove (1) plastic push-
pin rivet from outer bottom edge of fascia near wheel well, both sides.
2d. Remove fascia - Using a plastic trim tool, starting at the outer ends near
wheel well, carefully remove the fascia by gently pulling rearward while
releasing the clips holding the fascia. 2e, If equipped, disconnect all wiring
harnesses from fascia and carefully set fascia aside.
©2020 Horizon Global™ Corp - Printed in Mexico
2c. Remove fascia - Using a flat head screw driver, from inside the rear
wheel well, remove the top rivet located just below the seam of bumper
fascia. (1) per side. Do not remove the bottom (2) rivets from wheel well
area. Note: The factory rivets cannot be reused. Four (4) replacement
rivets are supplied, (2) required, (2) spare.
3. Remove bumper beam – using a 14mm socket with extension, remove (2)
M10 flange hex nuts and (4) M10 hex bolts from bumper beam.
Sheet 5 of 24 76333NP 03-02-20 Rev. A