Assembly Instructions - allen+roth LWSCT Instrucciones De Montaje

ASSEMBLY INSTRUCTIONS

1a. Unpack the unit and confirm that you have all the hardware and
required parts. Assemble the unit on a carpeted floor or the empty
carton to avoid any scratch.
1b. Securely screw five cam bolts (BB) into the designated threaded
inserts on the drawer front panel (D). Fully tighten with a phillips
screwdriver. DO NOT over tighten the cam bolts.
Hardware Used
Cam Bolt
BB
2. Attach drawer side panels (F and G) to the drawer front panel (D) by
engaging four small cam locks (EE).
Hardware Used
EE
Small Cam Lock
3. Slide the drawer bottom panel (C) into the grooves between the
drawer side panels (F and G) until fully rest into the groove of
drawer front (D).
1
BB
BB
D
x 5
2
Grooves line up with each
other and face inward
G
EE
x 4
D
3
C
G
D
6
ASSEMBLY INSTRUCTIONS
4. Attach the drawer bottom support (L) to the drawer front (D) with
one wood dowel (DD) and one small cam lock (EE).
NOTE: It is very important to use a small amount of glue on both
ends of dowels.
Hardware Used
DD Wood Dowel
BB
EE
Small Cam Lock
LL Glue
5. Fasten the drawer back panel (E) to the drawer side panels (F and G)
and drawer bottom support (L) with six 38 mm screws (GG).
Hardware Used
GG M4 x 38 mm Screw
F
EE
6. Attach the handle (KK) to the front of the drawer front panel (D)
with two handle bolts (JJ).
Hardware Used
Handle Bolt
JJ
Handle
KK
F
4
L
x 1
EE
x 1
DD
D
x 1
5
GG
GG
x 6
E
G
L
6
JJ
x 2
JJ
x 1
D
7
C
GG
F
KK