Tabla De Contenido - Generac 0055181 Manual De Instalación

Table of Contents .......................................... Inside Front Cover
Section 1 - General Information .........................................IFC
1.1 Introduction ...................................................................IFC
1.2 Battery Charger Compatibility ......................................... 1
1.2.1 Determination of Generator/Transfer
Switch Model Type ................................................ 1
Section 2 - Load Shed Transfer Switch Installation .............. 2
2.1 Load Shed Transfer Switch (RTSS) Installation .............. 2
2.1.1 Wiring and Connections at the Transfer Switch ... 2
2.1.2 Wiring and Connections at the Generator ............ 2
2.1.3 Operational Testing ............................................... 2
Section 3 - Standard or Service Entrance Transfer Switch
Installation .......................................................... 3
3.1 Standard Transfer Switch (RTSN) or (RTSE) Service
Entrance Rated Transfer Switch Installation ................... 3
3.1.1 Wiring and Connections at the Transfer Switch ... 3
3.1.2 Charger Mounting ................................................. 4
3.1.3 Wiring and Connections at the Generator ............ 5
3.1.4 Operational Testing ............................................... 6
Section 4 - GenReady Installation ........................................... 6
4.1.1 Wiring and Connections at the Transfer Switch ... 6
4.1.2 Charger Mounting ................................................. 7
4.1.3 Wiring and Connections at the Generator ............ 7
4.1.4 Operational Testing ............................................... 8
Section 5 - Notes .................................................................... 9
Section 6 - Interconnection Diagrams .................................. 12
For authorized service, reference
the dealer locator number found
in the generator owner's manual
or on the generator.
Table of Contents
1.1 INTRODUCTION
This battery charger supplies a trickle charging current and voltage
to maintain the charge on the generator starting battery inside the
generator enclosure. The charger will not replenish a fully dis-
charged battery. It is intended to be connected to a 120VAC gen-
erator backed-up circuit only. If it is not connected to a generator
backed-up circuit the battery could go "dead" while the generator
is running for extended periods of time.
Figure 1.1 - Charger as Supplied Indicating Input and
Output Wiring
AC Input

This battery charger must be properly installed
and wired for correct operation of all 2008
model line Air-cooled Standby Generators.
Failure to do so will result in a dead battery
condition at the generator.
This installation guide should be used in conjunction with the
"Installation and Owner's Manual" that is furnished with the
Air-cooled Standby Generator and the Installation and appropri-
ate transfer switch manual. Please review all manuals prior
to installation of the generator and transfer switch. This bat-
tery charger is not required with the Liquid-cooled Generator
product line. This battery charger is not required for Air-cooled
Standby Generators prior to the 2008 model line. This unit is not
compatible with other generator manufacturer's products.
DC Output
NOTE: