Section 1 - General Information; Battery Charger Compatibility; Determination Of Generator/Transfer; Switch Model Type - Generac 0055181 Manual De Instalación

These Installation Guidelines are designed to familiarize personnel
with the installation process for the battery charger required for
the air-cooled generator only. It does not replace or supersede any
information contained in any of the written documents shipped
with the unit. This booklet should only be used in conjunction with
the Owner's Manual, Installation Guide and other technical docu-
ments shipped with the unit.
Future product updates and/or modifications will be reflected in the
written documentation included with the equipment. Always read
all accompanying documentation carefully before attempting to
install any generator, transfer switch or related equipment.
It is essential to comply with all regulations established by the
Occupational Safety and Health Administration (OSHA) and
strict adherence to all local, state and national codes is manda-
tory.
This device should be installed with all local electrical codes
and/or the latest edition of the National Electrical Code. All wir-
ing must be the correct size and type, and must conform to local
codes, standards, and regulations.
Switch Type Switch Description
RTSD Pre-wire with 8 circuit load center
RTSF Pre-wire with 10 circuit load
ST100R10C center
Pre-wire with 12 circuit load
RTSH
center
RTSP Pre-wire with 14 circuit load
ST100R14C center
RTSW
Pre-wire with 16 circuit load
ST100R16C
center
KGATX0216100
RTSS
Power Manager LTS - Load Shed
KGALT0101200
with 16 circuit load center
SR200RDPM
RTSN
SRXXXR Standard
KGATX
RTSE
SRXXXRD Service Entrance Rated
KGATD
005448-0
005449-0
KGATD0101RSP
NOTE: Switch Type is the first four (4) digits of the model number and can be found on the data label inside the switch.
NOTE:
Notes
Battery charger is included and pre-wired with the trans-
fer switch. Discard this charger. No further installation is
required
Battery charger is included and pre-wired with the trans-
fer switch. Discard this charger. No further installation is
required
Battery charger is included and pre-wired with the trans-
fer switch. Discard this charger. No further installation is
required
Battery charger is included and pre-wired with the trans-
fer switch. Discard this charger. No further installation is
required
Battery charger is included and pre-wired with the trans-
fer switch. Discard this charger. No further installation is
required
Battery charger is included with the transfer switch. Proceed
with connections.
The included battery charger must be installed and con-
nected
The included battery charger must be installed and con-
nected
The included battery charger must be installed and con-
GenReady
nected
Section 1 — General Information
Battery Charger Installation Guidelines
1.2 BATTERY CHARGER
COMPATIBILITY
This battery charger is compatible, and required with all 2008
model line Air-cooled Standby Generators. For all generators that
were supplied with a transfer switch/load center, the charger is
already installed in the transfer switch enclosure and this charger
is not needed. For all generators that were NOT supplied with a
transfer switch/load center, the charger is NOT already installed
and MUST be installed according to these guidelines.

1.2.1 DETERMINATION OF GENERATOR/TRANSFER

SWITCH MODEL TYPE

The Battery charger included with this manual only needs to be
used with certain transfer switch configurations. Some transfer
switch configurations already have the battery charger installed in
the transfer switch. Before proceeding it is necessary to select the
transfer switch used from the following table.
Proceed to Section
Stop Here
Stop Here
Stop Here
Stop Here
Stop Here
2
3
3
4
1