Firing The Shooting Nails; Inspection And Cleaning; Disassembling The Powder Actuated Tool - DeWalt PA3500 Manual De Instrucciones

English

4.3 Firing the shooting nails

WARNING
Serious injuries due to accidental
triggering
Î
Always keep the ¿ ngers away from
the trigger if the Powder Actuated
Tool is not facing the target material.
Î
Determine the suitable ¿ ring strength
(power regulator) and charge using
a test attachment procedure, see
chapter 3.4 „Test attachment".
Î
If the cartridge does not ¿ re
immediately after pressing the
trigger, keep the Powder Actuated
Tool pressed against the target
material for at least another
30 seconds.
Î
For every workstation change:
Remove the cartridge strip and carry
the Powder Actuated Tool with the
barrel pointing down.
Î
After you ¿ nished working: ¿ rst
remove the cartridge strip and then
the shooting nail. Keep the Powder
Actuated Tool stored in the locked
tool box and store the cartridge strips
in a safe place – both components
separately from each other.
Î
Firmly grab the Powder Actuated Tool with
both hands and push the barrel against the
material to be fastened (90° angle, device
facing downward) (1).
Î
Pull the trigger (2).
2
38
1
90°
5

Inspection and cleaning

Powder Actuated Tools have to be cleaned after
use in order to remove the accumulated carbon
due to the combustion gases.
WARNING
Serious injuries due to accidental
triggering
Î
Remove the cartridge strip.
Î
Remove the shooting nail.
CAUTION
Hot surfaces
Î
Let the Powder Actuated Tool cool
down.
5.1 Disassembling the powder
actuated tool
NOTICE Parts may be damaged during
disassembly. Do not use damaged (bent)
attachment clips any more.
Î
Lift the attachment clips slightly using
a sharp object and remove them.
Î
Pull back the piston stop slightly and remove
it.