I.p. Approval Con¿ Rmation - DeWalt PA3500 Manual De Instrucciones

English
10 C.I.P. approval
con¿ rmation
The D WALT PA3500 device is type-approved
E
and system-tested. The square approval symbol
contains the registered approval number
"PTB S 824". With this, D
that the device complies with the approved type.
Inadmissible defects that are detected
during operation have to be reported to the
authority responsible for the approval (PTB
Braunschweig) as well as the Permanent
International Commission (Commission
Internationale Permanente pour l'Épreuve
des Armes à Feu Portatives), Avenue de la
Renaissance 30, B-1000 Brussels (Belgium).
Approval of the technical unit consisting of
type-approved tool and speci¿ ed cartridge in
a magazine is documented by system approval.
The test certi¿ cate numbers of the respective
system approvals are listed in the following
table:
D WALT
E
Magazined
cartridge stripes
for PA3500
D WALT 6,8/11
E
(.27 cal.), green
D WALT 6,8/11
E
(.27 cal.), yellow
D WALT 6,8/11
E
(.27 cal.), red
44
WALT guarantees
E
PTB
Test certi¿ cate
number of the system
approval
PTB Sy 824 DW 13
PTB Sy 824 DW 14
PTB Sy 824 DW 16