e-conolight E-MT1A Serie Instrucciones De Instalación

INSTALLATION INSTRUCTIONS
E-MT1A, E-MT3A, and E-MT4A Series
E-MT1A101G
E-MT4A101G
CAUTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety
precautions should always be followed including the
following:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS
1. DANGER- Risk of shock- Disconnect power before
installation.
DANGER – Risque de choc – Couper l'alimentation
avant l'installation.
2. This luminaire must be installed in accordance with the
NEC or your local electrical code. If you are not familiar
with these codes and requirements, consult a qualified
electrician.
Ce produit doit être installé conformément à NEC ou votre
code électrique local. Si vous n'êtes pas familier avec ces
codes et ces exigences, veuillez contacter un électricien
qualifié.
3. MIN. 75°C SUPPLY CONDUCTORS for E-MT1A101G.
All others require 60°C supply wire.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE
E-MT3A101G
www.e-conolight.com |
Document CI308X09R1
Created By: TMT
MOUNTING TO CONDUIT PENDANT MOUNTING
1. Complete the wiring to the power source (refer
to wiring instructions).
2. Thread the fixture onto the conduit.
3. Seal around the conduit using approved NEC
procedures.
4. Flats are provided at the top of the fixture to tighten
with a wrench.
CEILING/WALL MOUNTING
(E-MT1A101G, E-MT4A101G)
1. Attach the ceiling/wall box to
the mounting surface.
2. Pull leads to the box.
3. Complete the wiring to the
power source (refer to wiring
instructions).
4. Attach the arm by installing the
mounting screws in alternate
sequence (E-MT4A101G only).
LAMP INSTALLATION- SEE FIGURE 1
1. Loosen guard set screw.
2. Remove globe and guard assembly.
3. Incandescent 150 watt maximum (A21).
4. Re-install globe and guard assembly.
5. Tighten the guard set screw.
FIGURE 1
Socket
Assembly
Adapter
Screws
Socket
Screws
888.243.9445 | FAX: 262.504.5409
Date 9/21/2018
ECO# 009682
(E-MT3A101G)
Ceiling
Box
Gasket
Socket
Globe
Guard
Screws
Guard