Maintenance; Replacing The Bar And Chain - Ego Power+ CS1610 Manual Del Usuario

MAINTENANCE

WARNING:
parts may create a hazard or cause product damage.
WARNING:
power tool operation or when blowing dust. If the operation is dusty, also wear a dust
mask.
WARNING:
chain saw before inspecting, cleaning, or performing maintenance. A battery operated tool
with the battery pack inserted is always on and can start accidentally.
WARNING:
WARNING:
products, penetrating oils, etc. come in contact with plastic parts. Chemicals can damage,
weaken, or destroy plastic, which may result in serious personal injury.
CLEANING
◾
After each use, clean debris from the chain and guide bar with a soft brush. Wipe
the chain saw surface with a clean cloth moistened with a mild soap solution.
◾
Remove the side cover, and then use a soft brush to remove debris from the guide
bar, saw chain, sprocket, and side cover.
◾
Always clean out wood chips, saw dust, and dirt from the guide bar groove when
replacing the saw chain.

REPLACING THE BAR AND CHAIN

WARNING:
chain is very sharp. Always wear protective gloves when performing maintenance to the
chain.
NOTICE:
When replacing the guide bar and chain, always use the specified bar and
chain combination listed in the section: "Recommended Bar and Chain for this Chain
Saw".
36
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1610/CS1610-FC
When servicing, use only identical replacement parts. Use of any other
Always wear safety goggles or safety glasses with side shields during
To avoid serious personal injury, remove the battery pack from the
When cleaning the chain saw, DO NOT immerse in water or other liquids.
Do not at any time let brake fluids, gasoline, petroleum-based
Never touch or adjust the chain while the motor is running. The saw