Ego Power+ CS1610 Manual Del Usuario página 47

PROBLEM
Chain saw does
not cut properly.
Chain becomes
loose or drops
off the guide bar
during normal
use.
Bar and chain
running hot and
smoking.
56V LITHIUM-ION CORDLESS CHAIN SAW — CS1610/CS1610-FC
CAUSE
◾
Insufficient chain tension.
◾
Dull chain.
◾
Chain installed backwards.
◾
Worn chain.
◾
Dry or excessively stretched
chain.
◾
Chain not in bar groove.
◾
The chain will become
loose as the temperature of
the chain increases during
normal saw operation.
◾
Chain does not engage drive
sprocket.
◾
Check chain tension for over
tightened condition.
◾
Chain oil tank is empty.
◾
Debris in guide bar groove.
SOLUTION
◾
Readjust the chain tension, following
the chapter: "ADJUSTING THE
CHAIN TENSION".
◾
Sharpen the chain cutters, following
the chapter: "HOW TO SHARPEN
THE CUTTERS".
◾
Reinstall the saw chain, following
the chapter: "REPLACING THE BAR
AND CHAIN".
◾
Replace the chain, following the
chapter: "REPLACING THE BAR
AND CHAIN".
◾
Check the oil level. Refill the oil tank
if necessary.
◾
Reinstall the saw chain, following
the chapter: "REPLACING THE BAR
AND CHAIN".
◾
Tighten the chain tension, following
the chapter "ADJUSTING THE
CHAIN TENSION".
◾
Reinstall the saw chain, following
the chapter "REPLACING THE BAR
AND CHAIN".
◾
Re-tension the saw chain, following
the chapter: "ADJUSTING THE
CHAIN TENSION".
◾
Fill the tank with bar and chain oil.
◾
Clear the debris in the groove.
47