Vertical Mode Example; Finish Mode; Finish Mode Functions - Timex M821 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Distance: Distance traveled since the GPS-3D Sensor was
started (requires GPS-3D Sensor).
Altitude: Current height above sea level (requires GPS-3D
Sensor).
Elevation: Difference between your current altitude and the
altitude when you started the chronograph (requires GPS-3D
Sensor).

Vertical Mode example

You are heli-skiing in Banff on a run estimated at 2,700 vertical
feet (214 vertical meters). Curious about the accuracy of the
estimate as well as how long it will take you to make your run,
you start your GPS-3D Sensor, navigate to Vertical Mode and
press START as you take off down the mountain. At the end of
your run, you press STOP and then DISPLAY until you see
Ascent Rate and Elevation (expressed in a negative number since
you traveled downhill). Use this information to see how fast you
skiied and compare the Watch's expressed elevation to your
guide's estimate.
30

Finish Mode

INDIGLO®
night-light
To Navigate Mode
or hold for time
Start timing or
take a split.

Finish Mode functions

Finish Mode allows you to predict how much time it will take you
to finish a specified distance based on current GPS-3D Sensor
data. To help you stay on pace for your predicted finish, you can
also set the Watch to alert you if you are moving either too quickly
or too slowly for your desired pace.
NOTE: If you do not use the GPS-3D Sensor, Finish Mode
operates identically to Chronograph Mode, displaying only
time and lap information.
You must reset the chronograph to zero prior to operating
Finish Mode or it will not operate properly.
View performance
data
Stop timing
31

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

M515M185M850

Tabla de contenido