Publicidad
Idiomas disponibles
Idiomas disponibles
The measures of the previous page are expressed in external dimensions, ie, measuring from each end of the tube. Once the horizontal
elements are assembled correctly, proceed to form a rectangle with the measures provided below.
Take into account the position of the ends according to page 6, to take account of the reflector and drivendo not reverse.
To set the reflector to boom, position the plastic clamps of 13mm (EAHYP013) in positions where it belongs, and fixed with screws
DIN 912 M6x40.
To place the plate to the boom, use screws DIN 912 M6X20 and DIN 9021 M6 washer. This plate must be very firm for positioning the
element. Next step is similar to reflector mounting, use again DIN 912 M6x40 and Din 985 M6slft locking nuts once it is all assembled
antenna.
The fixing of the LOOP element, each element is using a Hose Clamp 8-12mm (P0100022) the 13 to 10mm diameter.
The final lenght is the pre-sintonized. The lenght is from the end of the 13mm tube to the outside of the bend tube.
HOSE CLAMP 8-12mm Ø
(P01000022)
13mm Ø
Placas 6m
DIN 912 6x40mm
DIN 985 M6
10mm Ø
66mm
ENGLISH
DRIVEN ELEMENT
DIN 912 6x20mm
DIN 9021 M6
Publicidad
