Important Safety Instructions; Mounting Instructions - ecolight GLC9163-BAL-I Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS

Never use with an extension cord unless plug can be fully inserted. Do NOT attempt to defeat
this feature.
WARNING: To reduce the risk of FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:
1. Use only insulated staples or plastic ties to secure the cords.
2. Route and secure the cords so that they will not be pinched or damaged when cabinet is
pushed to the wall.
3. Do not use an extension cord. Use power strip with integral overcurrent protection to
supply other electrical devices or accessories in cabinet.
4. Not intended for illumination of aquariums.
5. Not intended for recessed installation in ceilings, or soffits.
6. Do NOT attempt to install while plugged in.
7. For INDOOR USE ONLY.
8. Do NOT mount the LED lights to cabinets having a material thickness
less than 1/4 in.
9. Do NOT install these lights inside of enclosed cabinets.
10. Do NOT conceal line voltage power supply cord inside a wall, ceiling, soffit, kitchen
cabinet or similiar permanent structure.
11. Do NOT mount over sinks or stoves.
SAVE THESE INSTRUCTIONS IN A LOCATION CLOSE TO YOUR LIGHT FIXTURE SO YOU CAN
REFER TO THEM AT A LATER TIME.
IMPORTANT: These L.E.D. light heads use light emitting diodes to provide light. L.E.D.'s are
electronic semiconductors, and do not have a filament that can burn out like an ordinary light
bulb. As such, the L.E.D. light heads can last up to 50,000 hours when used intermittently, and
therefore, never need replacing.

Mounting Instructions

1
2
Mark the general area where the fixture is to be installed. When locating the positions
where the pucks will be mounted, be sure to take into consideration the power control unit
(on/off switch and dimmer control), the power hub, and the puck connector cords. NOTE:
Make sure your power control unit is within 5 feet of an electrical outlet, and that the
power hub is mounted within 18 inches of that power control unit. Also, the puck
connnector cords need to be able to reach the power hub. Measure and mark the
corresponding placement on the mounting surface for all units. Verify everything is
properly spaced before you drill your screw holes into the cabinets.
3
4
5
6
7
The LED light kit pucks may have the mounting caps
pre-installed on the top of the pucks (depending on the
production run). Rotate the cap counter clockwise and
remove them.
Locate the positions on the mounting surface where the pucks
are to be mounted and mark the center location of each puck.
Once the center points of the pucks have been determined,
hold each mounting cap in place and mark the two holes.
Dimple the surface with either an awl, a nail, or drill a small
pilot hole for the cap screws. Fasten the mounting caps with
two of the included cap screws.
Once the mounting cap is secure, bring the light puck to the
mounting cap, engage the three catches on the puck into the
three groves molded into the cap and turn clockwise.
Hold the power hub up to the mounting surface and mark the
locations for the mounting screws. Dimple the surface with
either an awl, a nail or drill a small pilot hole for the mounting
screws. Fasten the power hub to the cabinet with two of the
included mounting screws.
Hold the power control unit up to the mounting surface and
mark the locations for the mounting screws. Dimple the
surface with either an awl, a nail or drill a small pilot hole for
the mounting screws. Fasten the power control unit to the
cabinet with two of the included mounting screws.
- 2 -
Power control unit and
power hub MUST be
located outside of cabinet
in all installations.