WeatherTech 88TG13 Instrucciones De Instalación

Tailgate TechLiner
88TG13
1 1
Lower the tailgate and remove all tailgate accessories. Clean
your truck bed and tailgate with soap and water or TechCare®
Gentle Car™ Shampoo. Dry thoroughly before installation.
3 3
Meanwhile, use the enclosed Torx Bit to remove the 4 bolts
from the tailgate as shown. Set aside for later use.
5 5
Unroll the extrusion and discard the plastic tube. Avoid kinking
the extrusion. Place the extrusion against the edge of the
access panel with the opening facing the front of the vehicle
and centered on the tailgate. Slowly remove the adhesive
backing, pressing firmly as you go.
®
Installation Instructions
What You Need
¼" Drive Socket Set
or ¼" Wrench*
Parts Kit #88TG13
(1) T-30 ¼" Torx Bit
(6) Plastic Shoulder
Washers
(4) Alcohol Wipes
(3) Primer 94
Also In Box
(1) Rolled Extrusion
*Not included
2 2
Place Tailgate TechLiner on a dry, flat surface. Unfold and lay
out to flatten by placing small weights at each corner. For best
results, lay liner in the sun. Locate the hook and loop pads on
the bottom of the Tailgate TechLiner – keep them clean and
do not remove the backing yet.
4 4
Prep the plastic area just above the access panel using the
alcohol wipe and let dry. Shake the Primer 94 and then push
the center to crack open. Apply to the area the extrusion will
occupy and let stand for 5 minutes or until dry.
6 6
Lay the Tailgate TechLiner, hook and loop pads facing down,
onto the tailgate and ensure the features align. Do not remove
the plastic backing from the hook and loop pads at this time.