Optional Accessories - Makita GA011G Manual De Instrucciones

Operation with wire cup brush
Optional accessory
CAUTION:
Check operation of brush by run-
ning tool with no load, insuring that no one is in
front of or in line with brush.
NOTICE:
Avoid applying too much pressure which
causes over bending of wires when using the wire
cup brush. It may lead to premature breakage.
Usage example: operation with wire cup brush
► Fig.28
Operation with wire wheel brush
Optional accessory
CAUTION:
Check operation of wire wheel
brush by running tool with no load, insuring that no
one is in front of or in line with the wire wheel brush.
NOTICE:
Avoid applying too much pressure
which causes over bending of wires when using
wire wheel brush. It may lead to premature breakage.
Usage example: operation with wire wheel brush
► Fig.29

OPTIONAL ACCESSORIES

CAUTION:
These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita Service Center.
• Makita genuine battery and charger
► Fig.32
-
1
2
3
4
5
6
7
8
9
10
11
12
13
14
-
NOTE: *1 In some European countries, when using a diamond wheel, the ordinary guard can be used instead of the
special guard covering the both side of the wheel. Follow the regulations in your country.
NOTE: Some items in the list may be included in the tool package as standard accessories. They may differ from country to country.
100 mm (4") model
Inner flange and rubber pad 76
MAINTENANCE
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed before
attempting to perform inspection or maintenance.
NOTICE:
Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.
To maintain product SAFETY and RELIABILITY, repairs, any
other maintenance or adjustment should be performed by Makita
Authorized Service Centers, always using Makita replacement parts.
Air vent cleaning
The tool and its air vents have to be kept clean.
Regularly clean the tool's air vents or whenever the
vents start to become obstructed.
► Fig.30: 1. Exhaust vent 2. Inhalation vent
Remove the dust cover from inhalation vent and clean it
for smooth air circulation.
► Fig.31: 1. Dust cover
NOTICE:
Clean out the dust cover when it is
clogged with dust or foreign matters. Continuing oper-
ation with a clogged dust cover may damage the tool.
115 mm (4-1/2") model
Grip 36
Wheel Guard (for grinding wheel)
Inner flange
Depressed center wheel / Flap disc
Lock nut
Back up pad
Flex wheel
Rubber pad 100
Abrasive disc
Sanding lock nut
Wire wheel brush
Wire cup brush
Wheel Guard (for cut-off wheel) *1
Abrasive cut-off wheel / Diamond wheel
Lock nut wrench
16 ENGLISH
125 mm (5") model
Rubber pad 115