KALLISTA P70001-00 Guia De Instalacion página 3

Scrape off the old
wax seal
1. Remove the Existing Toilet
CAUTION: Risk of hazardous gases. If the new toilet is not
installed immediately, temporarily place a large damp rag in the
closet flange to limit exposure to sewer gases.
Turn off the water supply.
Flush the toilet.
Sponge out all remaining water from the tank.
Disconnect the supply shut-off valve, if present.
Use a utility knife to cut any sealant at the floor.
Remove the old tank and bowl.
Remove the old wax seal from the floor and the top of the toilet
flange with a putty knife.
Remove and discard the old T-bolts.
Install the new 5/16" diameter T-bolts.
Kallista
T-Bolt
Closet
Flange
3 1008379-2-A