Lift Rod
O-Ring
Flange
Tank Cover
Washer
Nut
4. Install the Lift Rod
Insert the flange into the center of the tank cover.
Insert the lift rod through the O-ring, then into the flange.
Hold the lift rod while placing the large washer and nut onto the
other end of the lift rod.
Hand tighten the nut until snug, then wrench tighten 1/4 turn.
Set the tank cover onto the tank so the cover bracket fits under
the vitreous china tab located on the back of the tank wall.
Carefully lift the front of the tank cover just enough to gain
access to the flapper chain and lift rod.
Insert the flapper chain S-hook into the middle hole in the lift
rod.
Verify the cover bracket and the vitreous china tab are engaged.
Kallista
Two-Piece Toilets
Lift Rod
Flapper
Chain
S-Hook
Tank
Tank
7
Tank
Cover
Flapper
Chain
1008379-2-A