KALLISTA P70001-00 Guia De Instalacion página 6

Tank Bolt
Washer
Gasket
Brass Nut
3. Install the Tank
NOTE: Three tank bolts come pre-assembled to the bottom of the
tank.
Remove the nuts and washers from the tank bolts. Set the nuts
and washers aside.
Position the tank on the bowl. Ensure the center of the tank
gasket aligns with the bowl inlet.
Assemble the washers and brass nuts onto each tank bolt.
CAUTION: Risk of product damage. Do not overtighten the
brass nuts. Overtightening may cause breakage or chipping of
vitreous china.
Tighten the brass nuts until the tank shows level and a watertight
seal is achieved.
1008379-2-A
Tank Bolt
Tank
Tank
Gasket
Bowl Inlet
Viewing The
Assembly From
Under The Tank
6
Tank
Kallista