Uline H-8263 Manual De Instrucciones página 2

7. Remove pop up outlets
from power center
casing by turning screws
counterclockwise.
(See Figure 3)
8. Insert power center
casing in corresponding
hole in tabletop (4).
(See Figure 4)
9. Secure power center to
tabletop (4) using four
M3.5 x 10 mm screws (F)
packaged with power
center. (See Figure 5)
10. Attach pop up outlets to
power center casing by
turning screws clockwise.
(See Figure 6)
PAGE 2 OF 6
ASSEMBLY CONTINUED
Figure 3
Figure 4
F
Figure 5
Figure 6
1-800-295-5510
uline.com
11. Stick adhesive-backed cable clips (G) under
tabletop (4) to secure and route cables.
(See Figure 7)
Figure 7
CONNECTING TWO TABLES (OPTIONAL)
1. Place wide legs of two tables together.
2. Align two flat brackets (E) with pre-drilled holes on
underside of tables. (See Figure 8)
3. Secure each flat bracket (E) using six M6 x 15 mm
bolts (B). (See Figures 8-9)
NOTE: Tables do not need to be flipped over
to connect together. Figure 8 is shown for
reference only.
Figure 8
Figure 9
G
B
E
0421 IH-8263