Uline H-6854 Manual De Instrucciones página 2

3. Use L-Brackets (E) to connect back panel (1) and
top panel (4). Attach using #4 x 5/8" screws (F). For
additional stability, L-Brackets can be installed to
connect side panels (2 and 3) to top panel (4), but
they must be positioned against the back corner to
allow clearance for pedestal installation. L-Bracket
holes can be started with a drill (optional).
(See Figure 3)
NOTE: The clearance between the pedestal
and back of desk will be 2⁄" when fully
assembled.
Figure 3
F
1
4
E
2
A
Cam Lock
Pin x 9
G
Grommet
Cap x 2
PAGE 2 OF 29
DESK SHELL ASSEMBLY CONTINUED
Tighten
D
3
1
4
L-DESK RETURN ASSEMBLY PARTS
B C
Cam Lock Dowel x 6
x 9
H I
Flat Bracket x 3
Lock Cap x 12
4. Insert glides (D) into side panels (2 and 3).
(See Figure 3)
5. Insert grommet caps (G) into top. (See Figure 4)
Figure 4
For Standard Desk assembly, proceed to
Pedestal Assembly on page 8.
For L-Desk assembly, proceed to L-Desk Return
Assembly below.
For U-Desk assembly, proceed to Credenza
Shell Assembly on page 4.
D
Glide x 4
J
Deep Cam Cap for Dowel
Holes x 2
G
E F
L-Bracket x 4 Screw x 47
#4 x 5/8"
K
Cap for Metal
Insert x 3
0921 IH-5679