Uline H-6854 Manual De Instrucciones página 3

1. Insert cam locks (B) into back panel (2) and side
panel (3). Insert cam lock pins (A) and dowels (C)
into top panel (1) and side panel (3). Attach panels
and tighten cam locks using a Phillips screwdriver.
(See Figure 5)
Figure 5
3
NOTE: Diagram shows right-hand L-Desk
configuration. For left-hand L-Desk
configuration, flip side panel (3) to opposite
side.
2. Insert glides (D) into back panel (2) and side panel
(3). (See Figure 6)
Tighten
Tighten
F
H
PAGE 3 OF 29
L-DESK RETURN ASSEMBLY
A
2
3
B
C
I
2
1
Figure 6
D
3
3 2
1
Tighten
F
1
2
E
1
3. Use L-Brackets (E) to connect top panel (1) and back
panel (2). Attach using #4 x 5/8" screws (F). L-Bracket
holes can be started with a drill (optional).
(See Figure 6)
NOTE: If installing a pedestal, L-Brackets are not
required on the end of the return.
4. Attach one side of flat brackets (H) to the top panel
(1) and back panel (2) using #4 x 5/8" screws (F).
(See Figure 6)
5. Carefully flip over return and attach other side of flat
brackets to the underside of the desk shell using #4
x 5/8" screws (F). (See Figure 7)
6. Insert grommet caps (G) into top and back panels
of return. (See Figure 7)
Figure 7
G
Right-Hand
Proceed to Pedestal Assembly on page 8.
F
OR
Left-Hand
0921 IH-5679