Uline H-6854 Manual De Instrucciones página 5

A
Cam Lock
Pin x 5
F
Screw x 53
#4 x 5/8"
1. Insert cam locks (B) into back panel (2). Insert cam
lock pins (A) and dowels (C) into top panel (1).
Attach panels and tighten cam locks using a Phillips
screwdriver. Insert glides (D) into bottom of back
panel (2). (See Figure 11)
Figure 11
Tighten
2
2. Use L-Brackets (E) to connect top panel (1) to back
panel (2). Attach using #4 x 5/8" screws (F). L-Bracket
holes can be started with a drill (optional).
(See Figure 12)
Figure 12
Tighten
1
H
PAGE 5 OF 29
U-DESK BRIDGE ASSEMBLY PARTS
B
Cam Lock x 5
G
Grommet
Cap x 2
U-DESK BRIDGE ASSEMBLY
2
A
2
C
1
2
2
1
1
C
Dowel x 3
H
Flat Bracket x 6
3. Attach flat brackets (H) to underside of both ends of
the top panel (1) and back panel (2) using #4 x 5/8"
screws (F). (See Figure 12)
4. Carefully flip over bridge and attach flat brackets
(H) to the underside of the desk and credenza shells
using #4 x 5/8" screws (F). (See Figure 13)
5. Insert grommet caps (G) into top and back panels.
B
(See Figure 13)
I
1
G
F
E
If Hutch was purchased for U-Desk, proceed to
U-Desk Hutch Assembly on page 6.
If Hutch was not purchased, proceed to
Pedestal Assembly on page 8.
D E
Glide x 2 L-Bracket x 2
I
Deep Cam
Lock Cap x 5
Desk
F
Figure 13
Bridge
Credenza
0921 IH-5679