Publicidad
Idiomas disponibles
Idiomas disponibles
3. Mark four holes on wall where screws will be inserted.
(See Figure 3)
Figure 3
Mounting
Locations
1.
Insert key into lock opening on top of dispenser and
turn to open cover. (See Figure 5)
Figure 5
2. Insert a roll on each arm and close lid.
(See Figure 6)
Figure 6
PAGE 2 OF 6
MOUNTING INSTRUCTIONS CONTINUED
LOADING INSTRUCTIONS
Arm
Roll
1-800-295-5510
4. Drill into wall at four marked locations with the
appropriate size drill bit. (See Figure 4) Insert wall
anchors if necessary.
Figure 4
5. Hold dispenser over previously drilled holes and
insert the screws. Tighten completely.
3. When first roll is out, slide access panel to the left to
begin using second roll. (See Figure 7)
Figure 7
NOTE: The roll on the left side must be used
completely before roll on the right can be used.
uline.com
Access Panel
0521 IH-5114
Publicidad
