Fusion 782-1730 El Manual Del Propietario página 16

Permanent Installation (1000,1500,2000 and 3000W Models)
The permanent installation of the inverter and the required wiring
and safety devices to the 12 Volt DC power source must be
performed by a professional installer.
Further Requirements Are:
• The inverter is supplied with (4) crimp connectors for
connecting the power source wiring to the inverter's DC input
terminals. They are designed to be crimped onto #2aWG
copper conductor cables (not supplied).
• The #2aWG power source cables must not exceed 6ft. in
length.
• A minimum of #16aWG insulated wire should be connected
between the grounding terminal on the inverter and the vehicle
chassis.
•cautIon:
!
Do not connect this wire to the inverter's negative (Black, -) DC
input terminals.
•cautIon:
Violation of these requirements may result in unsafe operation
and/or equipment failure. damage to the inverter as a result of
improper installation voids the warranty. The DC power source
must be a well-regulated DC power supply as typically found in
vehicle and deep-cycle marine batteries. The DC power source
may also be two 12 volt batteries connected in parallel. On
larger applications the power source may be several batteries
connected in parallel as shown in the following "Permanent
Battery Configuration" diagram on page 28.
16
InverterManual_012411.indd 16
All manuals and user guides at all-guides.com
1/31/11 8:43:21 AM