Fusion 782-1730 El Manual Del Propietario página 17

• cautIon: connection to Load
The inverters are equipped with dual standard North American
three-prong type outlets. Plug the cord from the equipment
you wish to operate into the AC receptacle(s). Check that the
combined load requirement of your equipment does not exceed
maximum continuous power of the inverter. Do not connect
the inverter to household's or RV's AC distribution wiring. Do not
connect the inverter to any AC load circuit in which the neutral
conductor is connected to ground or to the negative of the DC
(battery) source.
• WarnInG: Do not connect to any AC distribution wiring!
connecting to the uSB charging port
1) Connect the inverter to a 12 Volt DC power source describe in
the instruction manual. Check if there is adequate space for
proper ventilation of the inverter.
2) Press the power button to turn the unit ON.
3) The green power LED Indicator will light, indicating a
proper connection. If either the red LED indicator lights or
the alarm sounds, an error condition exists. Refer to the
"Troubleshooting" section of this instruction manual.
4) If the inverter does not work make sure the ignition/accessory
switch is actually powering the accessory outlet. Some
vehicles require the ignition switch to be turned on.
5) Plug the USB-powered device into the inverter's USB charging
port and operate normally. Remember to disconnect the
inverter from any power source when not in use.
InverterManual_012411.indd 17
All manuals and user guides at all-guides.com
17
1/31/11 8:43:21 AM