Aux In Operation; Radio Operation; Preset Stations - SOUNDMASTER High Line UR 2150USB Manual Del Usuario

AUX IN OPERATION

Caution: Turn off power and unplug the power cord before connection.
Connect to other audio equipment, including video recorder to provide sound output
for other audio equipment.
Preparation
. Connect these audio equipments "LINE OUTPUT" to "AUX IN" socket
of the unit through an audio cable (not included).
. Press the AUX IN / ON button once to turn on power and into AUX
IN mode.
3. The AUX indicator will light up on the LCD.
4. Press VOLUME +/- button to increase or decrease sound level.
5. To turn the unit off after use, simply press the
once.

RADIO OPERATION

. Press RADIO/BAND button once to turn on radio power, RADIO
will light up on the LCD.
. Press RADIO/BAND button again to select radio band.
3. Press the TUNE/TIME button + or – momentarily (less than 0.5 sec.) to step up or down
the receiving frequency in order to select the desired station.
4. For auto tuning, keep pressing the TUNE/TIME button + or – (more than 0.5 sec.) until
the displayed frequency starts to change, then release the button. Tuning will stop
automatically when a station is received.
5. Adjust the sound level by pressing VOLUME +/– buttons.
6. To turn the unit off after use, simply press
NOTE: After radio frequency is displayed for about 0 seconds, the LCD will show the current
time. Pressing the RADIO/BAND button once will show radio frequency again.
Improving the reception
• Extend the FM wire antenna which is located on the back of unit, and change its position
until the best FM reception is found.
• The unit has a built-in ferrite bar antenna for MW radio reception. Check the condition of
MW reception before fixing this unit in position.
• Install the unit as far as possible from a source of noise. (for example : refrigerator,
microwave oven, fluorescent lamp, etc.)

PRESET STATIONS

. Press the RADIO/BAND button to the desired band.
. When the desired station is tuned, press MODE / PROGRAM
button to enter saving mode.
3. The preset location will flash on the LCD, press PRESET/ALBUM
preset channel.
4. Press MODE / PROGRAM button again to save into memory. If it has previously set, the
former station is replaced.
5. Repeat step  ~ 4 to store more preset stations.
NOTE: The preset memory can store a maximum of  stations for FM band and  stations
for AM band.
RECALL A PRESET STATION
To recall any preset stations within the selected band, simply press the PRESET/ALBUM
/ buttons until the preset radio frequency appears on the display.
08B UR50USB IB 37.indd 7
STOP/OFF button
STOP/OFF button once.
GB - 7
/ button to select
00/5/4 0:45:5 AM