Ferroli GN2 N Instrucciones De Uso, Instalación Y Mantenimiento página 5

GN2 N
D
D Connect the panels together, using the screws 1, the washers 2 and the nuts 3,
reinforcing the bottom parts using the blades 4 fastened with the screws 5.
Loosen the nuts "A".
E
F Insert the side fastening bracket "A" between nuts "A" and "B".
A
B
G
Fit the side to the bracket "A" and fasten it using the screws "B" (right side view). Repeat the
G
operations in point G for the left side.
Fasten the sides to the rear wall "A" using the screws "B".
H
Unwind the hydrometer capillary tubing and tighten its connector to the sheathing on the front
I
of the boiler body.
Fit the wiring protection case "A" using the screws "B" on the sides.
L
M
M Fit the control panel to the sides using the tabs "A". Place the
reinforcement spring "B" between the head of the screw and
the tab.
A
P
B
A
H
A
B
A
Q
Fit the upper panel "A".
P
Q Fit the top cover or covers "A", according to the length of the boiler (see table 1, sequence C).
cod. 3541A581 - Rev. 02 - 03/2018
B
A
E
I
N
N Insert the 3 bulbs (safety thermostat, boiler thermostat and
thermohydrometer).
O Fit the lower front panel "A".
B
A
F
B
A
L
O
A
5