Connecting Antennas; Using External Antennas; Connecting An Ipod - Pioneer HTP-072 Manual De Instrucciones

02 Connecting your equipment
02

Connecting antennas

Connect the AM loop antenna and the FM wire antenna as
shown below. To improve reception and sound quality,
connect external antennas (see Using external antennas
below).
fig. a
ANTENNA
AM LOOP
4
FM UNBAL
75
1
1 Push open the tabs, then insert one wire fully into each
terminal, then release the tabs to secure the AM antenna
wires.
2 Fix the AM loop antenna to the attached stand.
To fix the stand to the antenna, bend in the direction
indicated by the arrow (fig. a) then clip the loop onto the
stand (fig. b).
3 Place the AM antenna on a flat surface and in a direction
giving the best reception.
4 Connect the FM wire antenna into the FM antenna
socket.
For best results, extend the FM antenna fully and fix to a wall
or door frame. Don't drape loosely or leave coiled up.
16
En

Using external antennas

To improve FM reception
Use a F connector (not supplied) to connect an external FM
antenna.
fig. b
2
To improve AM reception
Connect a 5 m to 6 m (16 ft. to 20 ft.) length of vinyl-coated
3
wire to the AM antenna terminal without disconnecting the
supplied AM loop antenna.
For the best possible reception, suspend horizontally
outdoors.
Indoor antenna
(vinyl-coated wire)
ANTENNA
F connector
FM UNBAL
75
Outdoor
antenna
ANTENNA
AM LOOP
5 m to 6 m
(16 ft. to 20 ft.)

Connecting an iPod

This receiver has a dedicated iPod/iPhone terminal that will
allow you to control playback of audio content from your iPod
using the controls of this receiver.
Note
•
An iPod/iPhone can be connected to the receiver. For details
on supported models and versions of the respective products,
see Playing an iPod on page 19 .
1 Switch the receiver into standby, and then use the iPod
cable to connect your iPod to the iPod/iPhone terminal on
the front panel of this receiver.
• For the cable connection, also refer to the operating
instructions for your iPod.
• When connecting an iPhone to this unit, keep the iPhone
at least 20 cm away from this unit. If the iPhone is kept
closer to this unit and a telephone call is received by the
iPhone, noise may be output from this device.
• iPod recharging occurs whenever an iPod is connected to this
unit. (Recharging is enabled only when the unit's power is
turned on.)