Saving Station Presets; Listening To Station Presets; Naming Preset Stations - Pioneer HTP-072 Manual De Instrucciones

03 Basic playback
03

Saving station presets

If you often listen to a particular radio station, it's convenient
to have the receiver store the frequency for easy recall
whenever you want to listen to that station. This saves the
effort of manually tuning in each time. This unit can
memorize up to 30 stations.
PARAMETER
TOP
MENU
TV
RECEIVER
SLEEP SOURCE CONTROL
RECEIVER
INPUT SELECT
INPUT
HOME
BD DVD CD
MENU
PTY
CH
TUNER iPod/USB SAT/CBL
GAME TV SIGNAL SEL
VOL
Acous.EQ S.RETRIEVER PHASE
1 Tune to a station you want to memorize.
See Listening to the radio on page 21 for more on this.
2 Press TOOLS.
The display shows PRESET, then a blinking MEM and station
preset.
3 Press PRESET / to select the station preset you
want.
You can also use the number buttons.
4 Press ENTER.
The preset number stop blinking and the receiver stores the
station.
Note
• If the receiver is left disconnected from the AC power
outlet for over a month, the station memories will be lost
and will have to be reprogrammed.
• Stations are stored in stereo. When the station is stored
in the FM MONO mode, it shows as ST when recalled.
22
En

Listening to station presets

You will need to have some presets stored to do this. See
Saving station presets above if you haven't done this already.
1 Press PRESET / to select the station preset you
want.
• You can also use the number buttons on the remote
control to recall the station preset.
AUDIO TOOLS
MENU VOLUME

Naming preset stations

For easier identification, you can name all of your preset
ENTER
stations.
1 Choose the station preset you want to name.
BAND
iPod CTRL
RETURN See Listening to station presets above for how to do this.
MUTE
2 Press TOOLS twice.
The cursor at the first character position is blinking on the
BASS TRE
display.
3 Input the name you want.
Choose a name up to eight characters long.
1 2 3
DISP
• Use PRESET / to select character position.
• Use TUNE / to select characters.
• The name is stored when ENTER is pressed.
Tip
• To erase a station name, follow steps 1 and 2, and press
ENTER while the display is blank. Press TOOLS while the
display is blank, to keep the previous name.
• Once you have named a station preset, Press DISP to
show the name. When you want to return to the frequency
display, press DISP several times to show the frequency.