HURAKAN HKN-FT44N Manual Del Usuario página 18

EN
to electrical shock.
●
High temperature can lead to burns. In the course of operation as well as before or after
operation, do not touch its housing or bowl because of high temperature.
●
It is not allowed to use power supply with other voltage characteristics. It is not allowed
to use the main switch, which does not conform to safety standards.
●
When there is thunderstorm or lightning outside, it is necessary to turn off the main
power switch in order to avoid damaging the machine by a lightning stroke.
●
Do not use heavy and sharp things, they can damage the machine housing or bowl
surfaces.
●
After completion of work, turn off the main power switch.
●
The machine installation and the support of electromechanical elements should be
carried out only by skilled personnel.
●
If the power cable is damaged, then for the purpose of safety the user shall contact the
manufacturer or the technical support department for replacement.
Attention!
●
In the course of operation, your hands, male connector and machine switch should be
dry.
●
The oil level should not be below the minimum mark. Do not switch the machine for
operation on idling.
●
It is not allowed to wash the electrical junction box by direct water flow or soak it.
●
It is not allowed to use old oil as it can lead to overboiling.
●
Cooking of excessively moist product as well as large volume products at a time can
lead to an accident.
F. Troubleshooting
Fault
1. After connection of
power supply, the light
indicator does not come on
and no heating occurs.
2. The light indicator is
alight but the temperature
does not rise.
3. The light indicator is
alight but the temperature
does not rise to the normal
level.
4. The temperature control
is performed but the
18
Cause
1. The male connector does
not adhere tightly.
2. The microswitch contacts
are not connected correctly.
1. The electrical heater
connection gets loose.
1. The temperature
controller has burnt out.
1. The indicator has burnt
out.
Remedy
1. Replace the male
connector.
2. Adjust the limit distance
of the microswitch.
1. Match and tightly screw
both parts of the electrical
heater.
2. Replace the electrical
heater.
1. Replace the controller.
1. Replace the indicator.