Troubleshooting - Hamilton Beach Durathon 19804 Manual Del Usuario

Troubleshooting

PROBLEM PROBABLE CAUSE
Iron won't heat. • Is iron plugged in and the outlet working? Check outlet by plugging in a lamp.
• Has a temperature been selected?
• Is the Auto Off light illuminated? Move or tilt the iron to reset.
Water is leaking. • Do not overfill the water tank.
• Adjust steam to a lower setting.
• If steam ironing, is the Adjustable Steam Switch in a steam position? Has a temperature been
• If dry ironing, make sure the Adjustable Steam Switch is in the
Iron won't steam. • Check water level.
• Is the Adjustable Steam Switch in the
• Has the iron had enough time to preheat?
• Anti-drip feature will not allow steam when temperature setting is in the dry range.
Iron leaves spots • ALWAYS empty water tank after using. Water left in tank may discolor clothing and soleplate.
on clothing.
Twisted cord. • If the iron cord should become twisted, unplug iron and let cool. Hold iron cord in the middle
Wrinkles not removed. • Choose correct temperature setting for your fabric.
Iron too hot/not hot • Adjust temperature to desired setting. Let iron cool down 5 minutes before continuing.
enough.
12
840221700 ENv02.indd 12 840221700 ENv02.indd 12
All manuals and user guides at all-guides.com
selected? Did the iron have enough time to preheat?
of entire length. Let plug and iron dangle freely until cord uncoils. This will extend the life of
the iron cord.
(Dry Iron) position.
(Steam) position?
11/12/12 11:56 AM 11/12/12 11:56 AM