Troubleshooting - Hamilton Beach 14690 Manual Del Usuario

Troubleshooting

PROBLEM
PROBABLE CAUSE
Iron won't heat. • Is iron plugged in and the outlet working? Check outlet by plugging in a lamp.
• Is the Temperature Control Dial turned to a fabric setting?
• Is the Auto Shutoff Light illuminated (Power ON Light is blinking)? Move the iron to reset.
Water is leaking. • Do not overfill the water tank.
• Adjust steam to a lower setting.
• If steam ironing, is the Adjustable Steam Control in a steam position? Is the Temperature
• If dry ironing, make sure the Adjustable Steam Control is in the
Iron won't steam.
• Check water level.
• Is the Adjustable Steam Control in the
• Has the iron had enough time to preheat?
• Anti-drip feature will not allow steam when temperature setting is in the dry range.
Iron leaves spots • ALWAYS empty water tank after using. Water left in tank may discolor clothing and soleplate.
on clothing.
Twisted cord. • If the iron cord should become twisted, unplug iron and let cool. Hold iron cord in the middle
Wrinkles not removed.
• Check Temperature Control Dial is set to correct fabric.
• Check Temperature Control Dial and adjust to desired setting. Let iron cool down 5 minutes
Iron too hot/not hot
enough.
10
840213600 ENv03.indd 10 840213600 ENv03.indd 10
All manuals and user guides at all-guides.com
Control Dial in the steam range? Did the iron have enough time to preheat?
of entire length. Let plug and iron dangle freely until cord uncoils. This will extend the life of
the iron cord.
before continuing.
(Dry Iron) position.
(Steam) position?
2/24/12 5:04 PM 2/24/12 5:04 PM