Panasonic ER-GD61 Instrucciones De Operación página 13

Without attachment
• Use without the attachment for design precise lines.
Place the blade horizontally against the skin and
towards the beard line trim slowly.
Trimming height: approx. 0.1 mm
(Fixed blade thickness is 0.1 mm)
Trimming height comb attachment
• The digit on the attachment indicates the target
trimming length.
• Actual beard length will be a little longer than the
height you set.
• The desired results may not be achieved if beard is
too long.
In this case, trim the beard to a length of about 20 mm
before using the appliance.
• Beard will be easy to accumulate in the attachment
when a lot of beard is cut. When this happens, clean
the attachment. (See pages 14 and 15.)
PB016970 - ER-GD6151 _(01GB)_12-04-18.indd 13
1
Turn the dial and adjust the
trimming height indication mark
( ) to the desired height.
b
• Trimming height:
approx. 0.5 mm to 10 mm
2
Apply the flat part of the comb against your
skin and cut your beard by combing it left and
right.
b
Flat part of the comb
13
2018/12/4 9:33:34