GE GX1S50R Manual Del Propietario E Instalación página 8

COLD WATER SUPPLY FITTING
(CONT.)
B. OPTIONAL HOME INSTALLATION
Saddle Valve: Saddle valve must be able to
connect with 1/4-inch tubing supplied with
the system. Not supplied with product; check
your local hardware or home service store for
OD tubing or larger.
NOTE: Codes in certain states require
installation by a licensed plumber and do
not permit the use of the saddle valve. For
installation, use plumbing code 248-CMR of the
Commonwealth of Massachusetts.
WARNING
If hole is required to be drilled
in pipe, to protect yourself from serious injury
or fatal shock, use a battery-powered hand
drill only to make the hole. DO NOT USE AN
ELECTRIC DRILL.
C. OPTIONAL INSTALLATION
Option 1
step 3.
Option 2
compression fittings to feed water adapter.
adapter.
5. Install compression fitting to pipe.
6.
step 3.
NOTE: Above described materials are not
included with the product.
Installation Instructions
INSTALL THE FAUCET
sink to make the needed connections. Before
starting, make sure there is sufficient room for the
A.
dispenser hole.
B.
C.
the sink.
NOTES:
seal.
of the faucet in case you need to remove it.
Installation Steps (refer to illustration
below for clarification)
Be sure to use the proper procedure for
drilling stone, porcelain or stainless steel.
Special drill bits may be needed. Consult a
qualified plumber for the proper procedure.
CAUTION
When drilling in Stainless Steel, the
4. Align the gasket to cover the hole completely.
into the hole.
Sink
Screw
Base
Gasket
Butterfly Bracket
49-6000026