OHAUS i-DT61XWE Manual De Instrucciones página 6

EN-4
7.
First loosen the M16 connector located at the bottom of the indicator, pass the
cable in the sealing kit through the M16 connector, adjust the length to a
suitable one, and then tighten the M16 connector. At the same time, connect
the two wire harnesses at the end of the cable to the instrument end
respectively, as shown below.
Ground terminal
8.
Pull in the bottom of the indicator. Re-install the 4 screws (Torque is
1.8N*m±0.5). Fasten the cap nut of cable gland.