Kichler Suri 11 Manual De Instrucciones

CAUTION – RISK OF SHOCK – Disconnect Power at the main
circuit breaker panel or main fuse box before starting and during
the installation.
Before Installing:
All installations should comply with National and
local electrical codes. If you have any doubts concerning
installation, contact a qualified licensed electrician.
1) Find the appropriate threaded holes on mounting strap that
align with hole distance in canopy. Thread mounting screws
into threaded holes starting from outlet box side.
2) Attach mounting strap to outlet box with strap mounting
screws. Mounting strap can be adjusted to suit position of
fixture.
3) Grounding instructions: (See Illus. A or B)
A) On fixtures where mounting strap is provided with a
hole and two raise dimples. Wrap ground wire from
outlet box around green ground screw, and thread into
hole.
B) On fixtures where a cupped washer is provided. Put
ground wire from outlet box under cupped washer
and green ground screw and thread screw into hole in
mounting strap.
If fixture is provided with ground wire. Connect fixture
ground wire to outlet box ground wire with wire connector,
after following the above steps. Never connect ground wire
to black or white power supply wires.
A
OUTLET BOX
GROUND
FIXTURE
GROUND
DIMPLES
GREEN GROUND
SCREW
Date Issued: 07/25/17
SOCKET
PORTALÁMPARAS
WIRE CONNECTOR
FIXTURE
GROUND
OUTLET BOX
GROUND
CUPPED
GREEN GROUND
WASHER
SCREW
MOUNTING SCREW
TORNILLO DE MONTAJE
CANOPY
ESCUDETE
LOCK-UP KNOB
PERILLA DE SUJECIÓN
4) Make wire connections. Reference chart below for correct
connections and wire accordingly.
5) Push fixture to wall carefully passing mounting screws with
holes in canopy. Make sure all wires are inside canopy and
do not get pinched between wall and canopy of fixture.
6) Thread lockup knobs onto mounting screws and tighten to
secure fixture to wall.
7) Insert recommended bulb(s). (Not supplied)
8) Raise the glass up through trim into fixture, passing over the
socket.
9) Turn glass to secure glass in place. (DO NOT over tighten)
10) Raise the lower trim over the glass and align the holes to pass
over the studs. Rest lower trim against the upper trim.
11) Slip a washer onto the stud, followed by threading on a finial.
Repeat for remaining studs. Tighten all finials to secure the
trim.
B
INSTRUCTIONS FOR MOUNTING
FIXTURE OUTDOORS AND/OR IN WET LOCATIONS:
1) Mounting surface should be clean, dry, flat and 1/4" larger
that the canopy on all sides. Any gaps between the
mounting surface and canopy exceeding 3/16" should be cor
rected as required.
2) With silicone caulking compound, caulk completely around
where back of canopy meets the wall surface to prevent water
from seeping into outlet box.
We're here to help
OUTLET BOX
CAJA DE SALIDA
WIRE
CONNECTORS
CONECTORES DE ALAMBRE
(2) STRAP MOUNTING SCREWS
TORNILLOS DE MONTAJE DE LA ABRAZADERA
MOUNTING STRAP
ABRAZADERA DE MONTAJE
STUD
CLAVO
GLASS
VIDRIO
LOWER TRIM
ADORNO INFERIOR
WASHER
ARANDELA
FINIAL
CAPUCHÓN
Connect Black or
Red Supply Wire to:
Black
*Parallel cord (round & smooth) *Parallel cord (square & ridged)
Clear, Brown, Gold or Black
without tracer
Insulated wire (other than green) Insulated wire (other than green)
with copper conductor
*Note: When parallel wires (SPT I & SPT II)
are used. The neutral wire is square shaped
or ridged and the other wire will be round in
shape or smooth (see illus.)
866-558-5706
Hrs: M-F 9am to 5pm EST
Connect
White Supply Wire to:
White
Clear, Brown, Gold or Black
with tracer
with silver conductor
Neutral Wire
IS-49857-US