Fagor MG9-10 Instrucciones Generales Para La Instalación, Uso Y Mantenimiento página 30

All manuals and user guides at all-guides.com
The positioning and electrical and gas installation should always be carried out by an AUTHORISED
TECHNICIAN, observing the standards of each country.
it is advisable to install an extraction hood for the optimum operation of the appliance.
Place the appliance in a well-ventilated place.
Level and adjust the height of the appliance. (Fig. 1)
An Authorised Technician, observing the regulations in each country, must always carry out the
appliance's gas connection.
The general installation must have a mains tap and a pressure regulator and it is also advisable to install a
shut-off cock on each individual appliance.
The gas inlet, and the hot and cold water inlet, as well as their position on the appliance, are defined in the
"General and connection dimensions" section"
An AUTHORISED TECHNICIAN should always carry out the appliance's electrical connection.
The legal standards in force in each country on connections to the mains should be taken into account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the connection.
Put an autonomous power switch with fuses into the mains socket, with a minimum distance between
contacts of at least 3 mm.
It is obligatory to earth the appliance. The manufacturer takes no responsibility if this requirement is not
fulfilled.
The section of cable sleeve and the rating of the fuses to be installed in the power switch are indicated in
table no 6
VERY IMPORTANT: When several appliances are installed in series, they should be earthed to each other
using the point assigned for this purpose, located in the rear part of the appliance.
The water intake and its location within the appliance are defined in the "General Dimension and
connection" with the letters "AF and AC". The water pressure must be between 2 and 4 bar and the
maximum temperature is 60ºC. The water intake in the machines is ½". To fill up the pan turn the water
inlet tap as shows Fig. 6 to the required position.
If the appliance is prepared for a different type of gas to the one available in the installation, you should
proceed as follows:
Cut off the gas to the appliance if connected. (Any conversion of the appliance's gas circuit must always be
carried out by a QUALIFIED TECHNICIAN).
1.- INSTALLATION
Positioning and levelling
Gas connection
Electrical connection
Water connection
Conversion to other types of gas
29