Fagor MG9-10 Instrucciones Generales Para La Instalación, Uso Y Mantenimiento página 33

All manuals and user guides at all-guides.com
Daily cleaning
In order for the appliance to work as new, it is advisable to follow the following instructions:
Do not use gritty and abrasive detergents for cleaning.
Do not use a water hose to clean the appliance.
Do not scratch the stainless steel surfaces with spatulas or iron wire brushes.
If they are not going to be used for a long while, cover the surfaces with a thin layer of Vaseline,
above all inside the tub.
Periodical cleaning.
It is advisable to regularly clean the inner part of the tub with soapy water that will be left to boil
for a few minutes, and then rinse it with plenty of water.
All the models require a greasing of the tub drain cock with "KLÜBER NONTROP PLB DR" or
similar grease after every usage to prevent it from seizing up.
Bain-Marie Model.
Never allow the bain-marie's level to drop too much. Check the level daily The adjustment valve of the
chamber is sealed to prevent it from being manipulated.
A screw is located on the lower part of the tub to empty the chamber completely.
Pressure Model.
The safety valve must always be clean. The cleaning of these parts will be carried out by boiling them in
soapy water and then rinsing them with clean water.
List of operating components.
Gas valve tap.
-
- Pilot
Thermocouple
-
Safety thermostat
-
IMPORTANT NOTE:
The replacement of any functional component that can affect the safety of the appliance must
be carried out by an AUTHORISED TECHNICIAN.
As a rule, whenever an operating component is replaced, you must check that the gas mains
tap is shut and that is no fire near the appliance.
3.- MAINTENANCE
32