English - IKEA GUNNARP Manual Del Usuario

English

ADD LIGHT SOURCES TO YOUR STEERING DEVICE:
Before you can use your light source you'll need to pair it with a steering
device.
To add more light sources, just repeat the steps below:
1. Make sure that your light source is installed and the main power switch is
turned on.
2. Hold the steering device close to the light source you want to add (no
more than 5 cm away).
3. Press and hold the pairing button
shine steadily on the steering device. Your light source will begin to dim
and finally flash one time to indicate that it has been successfully paired.
Up to 10 light sources can be paired with 1 steering device.
Make sure to pair them one at a time. If the light sources are close to each
other, disconnect those that have already been paired from the main power
switch.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS. Only use the control provided
with or specified by these instructions to control this bulb. This bulb will not
operate properly when connected to a standard (incandescent) dimmer or
dimming control. Only controllable by IKEA Smart lighting products.
The colour temperature can be switched between 2200K (warm glow), 2700K
(warm white) and 4000K (cool white).
for at least 10 seconds. A red light will
4