English - IKEA TRADFRI Manual Del Usuario

English

ADD LIGHT SOURCES TO YOUR STEERING DEVICE:
Before you can use your light source you'll need to
pair it with a steering device.
To add more light sources, just repeat the steps
below:
1. Make sure that your light source is installed and
the main power switch is turned on.
2. Hold the steering device close to the light source
you want to add (no more than 5 cm away).
3. Press and hold the pairing button
10 seconds. A red light will shine steadily on the
steering device. Your light source will begin to
dim and finally flash one time to indicate that it
has been successfully paired.
Up to 10 light sources can be paired with 1 steering
device.
Make sure to pair them one at a time. If the light
sources are close to each other, disconnect those
that have already been paired from the main power
switch.
CAUTION:
DO NOT USE WITH STANDARD DIMMERS. Only use
the control provided with or specified by these
instructions to control this bulb. This bulb will not
operate properly when connected to a standard
(incandescent) dimmer or dimming control. Only
controllable by IKEA Smart lighting products.
for at least
4